CaMMRa connection

CaMMRa connection

Register camera in DataFactory with it Serial Number (Standalone mode)


For events sending you have to go to the camera application and configure the data-sending:

Choose HTTP POST protocol, insert DataFactory server URL address example: http://10.0.5.100:5001/api/camera/events/upload 
▪ Enter camera ID in Sensor Provider ID field.
▪ Set check-boxes (Event type, Send data to server)

Make sure, that on settings page Full frame is set up:






    • Related Articles

    • Camera connection \ Storage

      Standalone mode of DataFactory Cameras connection Set camera’s: ▪ Name – enter your preferred name ▪ SerialNumber of camera. The camera must be configured to send events to the DF (see Installation Guide). ▪ Host address – for fast access to the ...

    • NumberOK connection

      General Settings: Cloud URL: This field allows you to specify the Cloud URL for uploading camera events. For example, the default Cloud URL may be "http://localhost:5001/api/camera/events/upload." Please note that "http://localhost:5001" represents ...

    • WisenetRoadAI, RoadWatch connection

      Register the camera in DataFactory with its Serial Number (Standalone mode) WisenetRoadAI RoadWatch For both types of applications configure the settings as shown in the screenshots. Most important settings: ▪ Send recognition events set to Basic ...

    • System requirements

      To ensure optimal performance of the FF DataFactory (DF) web application, the following system requirements must be met: Minimal Server Requirements: CPU: Intel i5 10th Gen or higher. Minimum free RAM: 4GB. Minimum disk space: 600MB for installation. ...

    • WAVE integration

      DataFactory should be installed in VMS mode. On the DataFactory setting page check “Other” in VMS connection section and enter WAVE connection host and credentials After clicking on the “Submit” button the camera list will pulled into DataFactory, ...